Rericoh printer toner replacementplacing Print Cartridges
Rericoh printer toner replacementplacing Print CartridgesTop PageTroubleshootingReplacing Print Cartridges
Do not allow clips, staples, or other small objects to ll inside the machine.
Do not expose the print cartridge without its cover to direct sunlight for a long time.
Avoid getting toner on your clothes or skin when removing a jam or replacing toner. If your skin comes into contact with toner, wash the affected area thoroughly with soap and water.
Do not shake the removed print cartridge. Doing so can cause remaining toner to leak.
The actual number of printed pages varies depending on image volume and density, number of pages printed at a time, type and size, and environmental conditions such as temperature and humidity. Toner quality degrades over time. Early replacement of print cartridges might be necessary. Therefore, we recommend you always keep new print cartridges ready.
Pull up the lever on the top cover, and then carefully raise the top cover.
The toner color is indicated by the label on each print cartridge.
WordStr the indicated print cartridge when any of the following messages appear on the screen:
Hold the print cartridge and shake it from side to side five or six times.
After closing the top cover, wait until the initial screen is displayed.
If toner or used toner is swallowed, dilute by drinking a large amount of water. Consult a doctor if necessary.
If black toner runs out, you cannot print in black and white or color until the black print cartridge is replaced.
Place the old print cartridge on or similar material to avoid dirtying your workspace.
If toner or used toner gets into your eyes, flush immediately with large amounts of water. Consult a doctor if necessary.
Make sure that the exposure glass cover or ADF is closed.
Put the cover that you removed in step 5. on the old print cartridge. Then, put the old print cartridge into the bag, and then put it into the box.
Prepare the indicated print cartridge when any of the following messages appear on the screen:
If toner or used toner is inhaled, gargle with plenty of water and move into a fresh air environment. Consult a doctor if necessary.
Comply with the print cartridge Recycling Program, whereby used print cartridges are collected for processing. For details, ask your sales or service representative.
Check that the toner color and location correspond, and carefully insert the print cartridge vertically.
Keep toner (used or unused) and toner containers out of reach of children.
Make sure to cover the old print cartridge with the protective cover for recycling and environmental purposes.
Do not store toner, used toner, or toner containers in a place with an open flame. The toner might ignite and cause burns of a fire.
The supplier shall not be responsible for any damage or expense that might result from the use of parts other than genuine parts from the supplier with your office products.
Take the new print cartridge out of the box, and then take it out of the plastic bag.
If toner gets on your clothing, wash with cold water. Hot water will set the toner into the bric and may make removing the stain impossible.
Tilt the print cartridge forward and pull it out.
Do not touch the print cartridges photo conductor unit.
Do not incinerate used toner or toner containers. Toner dust might ignite when exposed to an open flame. Dispose of used toner containers in accordance with local regulations.
If cyan, magenta, or yellow toner runs out, you can print in black and white using just the black toner. Change the color mode setting to Black and White using the machines driver.
Using both hands, hold the center of the top cover and close the cover carefully. Be careful not to trap your fingers.
When removing print cartridges, be careful not to touch the Laser Scanning Unit on the underside of the upper cover (the white area in the illustration below).
For good print quality, we strongly advise you use genuine print cartridges only.
From the rear, the print cartridges are installed in the order of cyan (C), magenta (M), yellow (Y), and black (K).
Even distribution of toner within the bottle improves print quality.